Desired Future Condition Worksheet | Version 3.0
Getting Started | Help | About This Version | Retrieve Data | Reset Form
Landowner – Enter name of legal landowner or contact person

Address – Enter address of landowner or contact person

Phone – Enter phone number of landowner or contact person

Project Name – Enter a project name. Project names are required.

Legal description – Enter section, Township, Range (E)(W) where stream segment is located.
General Information
Stream Segment – Enter the stream or stream segment label where DFC data was collected. This can be a name, number, letter or combination. A separate DFC calculation must be run on each stream or stream segment within the project. Stream with its corresponding label must be identified on your Forest Practices application map.

Site Class – Choose 1,2,3,4,5

Major Species – Choose Douglas fir or Hemlock

Stream Size – West Side: Choose "Small" if bankfull width less than 10 foot wide or "Large" if 10 feet wide or greater. East side: Choose "Small" if bankfull width is less than 15 feet wide or choose "Large" if bankfull width is 15 feet wide or greater.

RMZ Length ft. – Inter length in feet of the RMZ, or segment of the RMZ being evaluated.

Eastside High Altitude RMZ – Check this box only if stand is an Eastern Washington High Elevation timber habitat above 5000 ft.
Site Information
Landowner  
Address  
Phone  
Project Name  
Legal Description      
Stream Segment  
Site Class  
Major Species
Stream Size
RMZ Length (ft)  
Eastside High Altitude RMZ?
Stand Age – Enter stand age of core zone.

DBH Classes Total – Enter number of DBH classes found in the core zone. This must be entered before inputting data into the Stand Table.

Stand Table Data for Core Zone only –
Enter DBH class in order from smallest to largest.
Enter number of conifer trees in DBH class
Enter number of hardwood trees in DBH class
After all core zone data has been entered click on the Calculation button located at the bottom of the grid. If programs fails to calculate check for data entry errors. Red mark in fields will indicate unacceptable data entry.


Core Zone Acres, Trees/Acre, Basal Area/Acre and Percent Conifer are the existing core zone stand conditions and will self populate.
Core Zone Stand Table
Stand Age
DBH Classes Total
Enter your data in the grid and proceed to the Inner Zone Stand Table.
Core Zone Acres Basal Area / Acre Trees / Acre Percent Conifer
DBH Class Conifer Hardwood
Stand Age – Enter the stand age of the inner zone.

Widest Zone Width - is self populating and is the same width as your cruise strip width used in collecting your data. The DFC software computations assume that the Inner Zone cruise strip width shown in this block was used in collecting the field data entered in the Inner Zone Stand Table. This is necessary because there are two possible Inner Zone Widths depending upon which management option is ultimately chosen by the landowner. Therefore to insure that the field data is collected in such a way as to cover either alternative the widest Inner Zones Width must be used as the Inner Zone Cruise strip. Confirm that your inner zone cruise strip width matches.

DBH Classes Total – Enter number of DBH classes found in the inner zone. This must be entered before inputting data into the Stand Table.

Stand Table Data for Inner Zone only –
Enter DBH class in order from smallest to largest.
Enter number of conifer trees in DBH class
Enter number of hardwood trees in DBH class
After all inner zone data has been entered click on the Calculation button located at the bottom of the grid.


Inner Zone Acres, Trees/Acre, Basal Area/Acre and Percent Conifer are the pre-harvest inner zone stand conditions and will self populate.

If the combined projected basal area per acre of the combined core and inner zones at age 140 is less than the required basal area of 325, no inner zone harvesting will be allowed. Refer to WAC 222-30-021 (1)(b) "Stand Requirement"
Inner Zone Stand Table
Stand Age
Widest Inner
Zone Width
DBH Classes Total
Enter your data in the grid and proceed to the 'Calculate' button.
Inner Zone Acres Basal Area / Acre Trees / Acre Percent Conifer
DBH Class Conifer Hardwood